Thingiverse
Groovemount Plate E3D Printrbot original
7
Downloads
7
Likes
0
Makes
27.11.2016
As my E3D after some time started to move a little bit, I decided to add 2 3 mm holes and a mount piece that would hold the connecting part of the E3D pretty tight in there .
The only downfall is that you need to add really long 3 mm bolts, I have some but they are not so common .
Better solution would be to not go through with the holes and just add some captive nuts so that normal 30 mm bolts can be used to tighten the E3D .
I started editing this so I can mount an E3D Lite h
As my E3D after some time started to move a little bit, I decided to add 2 3 mm holes and a mount piece that would hold the connecting part of the E3D pretty tight in there .
The only downfall is that you need to add really long 3 mm bolts, I have some but they are not so common .
Better solution would be to not go through with the holes and just add some captive nuts so that normal 30 mm bolts can be used to tighten the E3D .
I started editing this so I can mount an E3D Lite h
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in