Thingiverse
Tarantula fan duct LH
by colindo
190
Downloads
113
Likes
6
Makes
The fan duct consists of a left and a right side and are screwed together when mounting the 40 x 40 motor.
It is better to print the left side and then right side, you will have to mirror the file to get the right side. Print upside down with the motor side to the table. See Cura attachment.
The duct is attached to the hot end mounting bracket, using two existing screws holding the hot end.
I turned the hot end so the element and wires are at the back, leaving room for the cables to clear t
It is better to print the left side and then right side, you will have to mirror the file to get the right side. Print upside down with the motor side to the table. See Cura attachment.
The duct is attached to the hot end mounting bracket, using two existing screws holding the hot end.
I turned the hot end so the element and wires are at the back, leaving room for the cables to clear t
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in