Thingiverse
Raspberry Pi 2 Exoskeleton
by boverby
39
Downloads
26
Likes
0
Makes
Inspired by http://www.thingiverse.com/thing:374377 by SOUNDSK
His design was modified to fit the Raspberry Pi model 2/3 and provide
more mounting options.
Assembly can use 4x #2 screws or 4x M3x10 cap head screws to hold
the two halves together. Lots of other pass holes ( some with hex nut
recesses ) to allow more bracketry or mounting. The pc board is
"pinched" between the upper and lower components.
The assembly and the two halves supplied in Designspark format (.rsdoc).
T
His design was modified to fit the Raspberry Pi model 2/3 and provide
more mounting options.
Assembly can use 4x #2 screws or 4x M3x10 cap head screws to hold
the two halves together. Lots of other pass holes ( some with hex nut
recesses ) to allow more bracketry or mounting. The pc board is
"pinched" between the upper and lower components.
The assembly and the two halves supplied in Designspark format (.rsdoc).
T
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in