Thingiverse
Lasercut resistor breadboard folder 2.0
by JackCarter
85
Downloads
70
Likes
1
Makes
There is 2.0 version of my breadboard resistor deformer. I put a 7mm width large hole in the middle to have a nice flat wire at the borders of the resistance.
Note that the numbers corresponding to the number of hole separating is updated, there was an error in the 1.0 version.
Enjoy !
Note that the numbers corresponding to the number of hole separating is updated, there was an error in the 1.0 version.
Enjoy !
Sign in to leave a comment
Sign in