dc42 IR Sensor Mount for D-Bot

This is a remix of the e3dV6 clamp for the D-Bot that adds a bracket to support the IR Height sensor from dc42 (David Crocker).

This replaces the current hot end clamp and uses the same length fixing screws. The IR sensor mount has slotted holes to allow height adjustment.

Print flat side down. Best with ABS or PETG rather than PLA as it is very close to the hot end. You will need two M2.5 or M2 bolts, nuts, and spacer washers to mount the IR board to the bracket.

Modified using Fusion