Thingiverse
Sagging Stepper Support (Parallelism fix for X axis)
by bradjshannon
4
Downloads
2
Likes
0
Makes
Two printed parts. One large bolt (outer dia. up to 6.6mm) required.
Used to lift the base of a printer's x-stepper if it begins to sag. My printer's left carriage is made of PLA and began to warp a bit when the x-stepper overheated (voltage was too high), leaving the x-axis drive system slightly out of alignment.
This is a temporary fix until I design and print carriages that don't have this problem!
Used to lift the base of a printer's x-stepper if it begins to sag. My printer's left carriage is made of PLA and began to warp a bit when the x-stepper overheated (voltage was too high), leaving the x-axis drive system slightly out of alignment.
This is a temporary fix until I design and print carriages that don't have this problem!
Sign in to leave a comment
Sign in