Thingiverse
Filament cutter (only 18mm snap off blade needed)
by JeEk
212
Downloads
154
Likes
1
Makes
Yet another filament cutter for 1.75mm filament..
The filament is cut in an angle by sliding the blade forward.
Goal:
Fully printable small filament cutter. No need for springs, screws, washers, nuts or anything else that requires the correct dimensions. The only hardware is a blade from a standard box cutter (with snap-off blade). The snapped part should be 18mm..
I managed to design this from scratch with good functionality. I must admit that it was a little bigger than what I though
The filament is cut in an angle by sliding the blade forward.
Goal:
Fully printable small filament cutter. No need for springs, screws, washers, nuts or anything else that requires the correct dimensions. The only hardware is a blade from a standard box cutter (with snap-off blade). The snapped part should be 18mm..
I managed to design this from scratch with good functionality. I must admit that it was a little bigger than what I though
Sign in to leave a comment
Sign in