Thingiverse
Stand for a water jar
by erognlid
2
Downloads
1
Likes
0
Makes
A stand for a water jar so it can sit on top of an a sink. Adapted to fit the edge of the sink.
Printed in ABS
I printed this in three sections. The top plate as one and the feet's as on(two). The reason for this was to not use support and also to be able to adjust the feet's on site if needed.
Printed in ABS
I printed this in three sections. The top plate as one and the feet's as on(two). The reason for this was to not use support and also to be able to adjust the feet's on site if needed.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in