Customizable Gluing Jig for Folger Tech Kossel Carbon Fiber Arms

This is what I used to glue the 6 rods on my Folger Tech Kossel 2020. I fine tuned the openscad file to make it customizable. You should be able to use this with other size rod ends by changing a few variables.

When using this jig, the only problem I had was getting a little super glue on the clamp while gluing all 6 at once. Next time I would probably glue 2 or 3 at a time rather than all 6. At any rate, my arms came out quite well since my prints come out quite accurate. I made the ver