IKEA Lack Enclosure Risers x 100mm

I liked the design that McCarter14777 used, but I needed the riser to be a bit taller. This should raise the IKEA Lack legs 101.5mm or so off the surface it's on. This was enough to give my Monoprice Maker Select (Wanhao i3 v2.1 clone) enough room, even with my raised z Axis mod.

I printed this with eSUN ABS+. I printed it at 0.3mm at 80mm/sec. Probably would have been better if I slowed that down. I did have to use a temporary cardboard box to keep the part from delaminating. I'd have