Thingiverse
Raspberry Pi 3 sleeve case improved fit
by commonslabgr
33
Downloads
19
Likes
1
Makes
This design is an improvement from this: http://www.thingiverse.com/thing:902390 which again is a remix from this http://www.thingiverse.com/thing:604915.
The modifications which were made to improve the ease of sliding in and out the Raspberry Pi are just two.
First we increased a bit the groove at both sides and also added a slope at the bottom so that the Pi can slide up into place easily.
The modifications which were made to improve the ease of sliding in and out the Raspberry Pi are just two.
First we increased a bit the groove at both sides and also added a slope at the bottom so that the Pi can slide up into place easily.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in