Revised Stryfe Reload Facilitator Magwell

This piece is a revised edition of http://www.thingiverse.com/thing:1800483, by jojifortaleza. The original design did not accept a magazine, so i revised it, and now it works. Enjoy!

Note: you need a rather tall printer (>150mm Y axis), and the overhangs can prove hard on the part. The photo of the two magwells is a comparison of jojifortaleza's (left) and mine (right)

The other parts that are shown in the photo are also available, see links below:
Mag release: http://www.thingiverse.com