E3D v5 Fan Shroud for Delta Mini Kossel Effector with Z probe

My filament was constantly jamming due to the filament being too hot in the heat sink, which was resolved by (1) lower print temperature and (2) better cooling for the heat sink.

I made this fan shroud to help improve #2.

The part that slots into the heat sink is tight enough and strong enough to hold the whole assembly on; however, you can additionally use an M3x15 or M3x20 bolt/nut, with the bolt coming from the inside of the fan out and the nut on the back of the shroud.

You may need