1858 cylinder

Cylinder for an 1858 Remington Army black powder revolver. I wanted to learn Fusion 360, and chose this part because it was a bit complex, and I knew I could learn a lot by drawing it. After some cleaning up and a little sanding, the cylinder actually fit the frame and worked properly, even locking up and rotating as it should. The nipple hole threads didn't print, but I didn't care because I was just using it as a learning tool.

Be sure to stand the part vertically with the large holes facing downward, to get the best print.

This part is simply intended as a fun, unique part to print. I'm sharing it because I put so much time into it. I didn't draw any of the other parts. If nothing else, you can make it into a unique pencil holder for your desk.