Thingiverse
D810 Fan Duct (Zonestar)
by Tysonpower
10
Downloads
11
Likes
0
Makes
This is a fan duct for the D810 Delta Printer from Zonestar.
The newer versions have a fan duct already installed, but it is not working great at all.
So i designed one that attaches to the extruder top plate, with two self tapping Screws (like the ones on the endstops) and uses the original fan. You also need a m3 screw and nut to connect the two pieces together. It also allows you to angle the fan duct to adjust the aitflow direction.
The results of the Prints are much better. No Over
The newer versions have a fan duct already installed, but it is not working great at all.
So i designed one that attaches to the extruder top plate, with two self tapping Screws (like the ones on the endstops) and uses the original fan. You also need a m3 screw and nut to connect the two pieces together. It also allows you to angle the fan duct to adjust the aitflow direction.
The results of the Prints are much better. No Over
Sign in to leave a comment
Sign in