Fan support MKS 1.4 Prusa I4 (60 x 15mm fan)

This support can be fitted to the mainbord MKS 1.4 of prusa I4. It was made to apply a 60 x 15 mm fan inner the box of the printer without make holes on the printer. I used a 12V fan connected to the general 12 V from the step down circuit.
NOTE: the support have an orientation of assembly, the fan must stay over the drivers, on the opposite side one of the fitting arms has a notch, take care to align the notch so as not press on the little capacitor SMD marked C4.