Battrey Spacer for Traxxas LCG & HCG 2wd Slash

I designed this battery spacer and have it 3-D printed out and one
of my local hobby shops to replace the two-piece foam spacers
that I use to fill in the gap between the lipo battery and the chassis
of this traxxas 2wd slash that you see here in the photos if you wish
to download this RC accessory you do not need much only a good 3-D printer
and the battery must be 137.29mm in length as far as hard case lipos are
concerned. and it must be a traxxas 2wd slash LCG or HCG you may need
do