Thingiverse
18650 2P battery case
by cpt_tesa
6
Downloads
3
Likes
0
Makes
Parts needed for this:
2x 18650 cell
1x TP4065 lithium charging module
1x MT3608 DC-DC step-up module
some flexible and solid copper wire
I needed a 18650 battery holder for my R/C Boat. This compartment also includes a TP4065 lithium charging module and a MT3608 DC-DC step-up converter. The output voltage can be adjusted from battery power up to 28V/DC. There is a small hole on the side of the model, where the potentiometer can be accessed. There are also some holes, to see the LEDs during charging. A M3 screw will self-thread itself in the corresponding hole. I charged both cells completely, before connecting them in parallel.
I will not take any response when cells catch fire, nor any other damages due to this build.
2x 18650 cell
1x TP4065 lithium charging module
1x MT3608 DC-DC step-up module
some flexible and solid copper wire
I needed a 18650 battery holder for my R/C Boat. This compartment also includes a TP4065 lithium charging module and a MT3608 DC-DC step-up converter. The output voltage can be adjusted from battery power up to 28V/DC. There is a small hole on the side of the model, where the potentiometer can be accessed. There are also some holes, to see the LEDs during charging. A M3 screw will self-thread itself in the corresponding hole. I charged both cells completely, before connecting them in parallel.
I will not take any response when cells catch fire, nor any other damages due to this build.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!