18650 Battery Case (x4)

Link to Fusion360 File (because makerworld hates me for some godd*mn reason and won't let me upload it) TL;DR: This is a very simple 4x18650 Battery Holder. It is made to have nice clearance on all axis' to ensure that no matter what wrap you have (stock or aftermarket) it should fit nicely inside without being too snug. Download it, print it, forget it. Its one of those prints that work so well you don't even think about it. The lid is held on via tension. It is not too difficult to pull off, but still snug enough that you can throw it in a bag without worrying about your batteries falling out. You can hold this case upside down fully loaded with 4 batteries and none will fall out. I recommend using PLA instead of PETG as PETG is a little more “slippy”. It has been created to “break-in”, so it'll feel a bit tight at first. This is normal and is intentional. Simply take any graphite pencil and draw a few lines on the connection points on both the male and female ends to