Thingiverse
Electronics
Go to Model
18650 Battery Project Box
88
Downloads
80
Likes
0
Makes
This is a simple box to contain a 18650 LIPO battery mounted in a plastic spring battery holder (as bought on eBay).
The length is extended and has a cut-out to allow putting in a USB battery module that has a micro USB charging input and a 5V boost USB socket output. These are also available on eBay very cheaply (search for micro USB boost charging module)
The scad file allows for adding on space (e_width) to the side of the battery to contain project electronics.
The stls have this compiled for 0mm, 10mm, 20mm, 30mm, 40mm. The 0mm version is intended just for a simple battery store with 5V USB output.
The scad can also be set to cover up the USB A output socket if this is not required.
The length is extended and has a cut-out to allow putting in a USB battery module that has a micro USB charging input and a 5V boost USB socket output. These are also available on eBay very cheaply (search for micro USB boost charging module)
The scad file allows for adding on space (e_width) to the side of the battery to contain project electronics.
The stls have this compiled for 0mm, 10mm, 20mm, 30mm, 40mm. The 0mm version is intended just for a simple battery store with 5V USB output.
The scad can also be set to cover up the USB A output socket if this is not required.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
