Thingiverse
18650 Battery Rack
von Kawah07
28
Downloads
15
Likes
0
Makes
This is a well-designed, 3D printable rack for storing 18650 batteries. It's practical and a must-have for anyone who uses these common rechargeable cells in their devices. The open design allows for quick and easy access, while the sturdy structure keeps your batteries organized and safe from rolling away.
----------------------------------------------------------------------
Settings and Manufacturing Instructions
This model is optimized for FDM 3D printing and is very easy to print.
Machine Type: FDM (Fused Deposition Modeling)
Material: PLA, ABS, or PETG are all suitable. PLA is recommended for its ease of use.
Resolution/Layer Height: 0.2mm is a good balance of speed and detail.
Infill: 15-20% is sufficient for a strong, stable print.
Supports: No supports are needed for this design due to its self-supporting geometry.
Manufacturing Time: Approximately 4-6 hours, depending on your printer's speed settings.
Safety Standards: This is a non-critical, decorative/organizational
----------------------------------------------------------------------
Settings and Manufacturing Instructions
This model is optimized for FDM 3D printing and is very easy to print.
Machine Type: FDM (Fused Deposition Modeling)
Material: PLA, ABS, or PETG are all suitable. PLA is recommended for its ease of use.
Resolution/Layer Height: 0.2mm is a good balance of speed and detail.
Infill: 15-20% is sufficient for a strong, stable print.
Supports: No supports are needed for this design due to its self-supporting geometry.
Manufacturing Time: Approximately 4-6 hours, depending on your printer's speed settings.
Safety Standards: This is a non-critical, decorative/organizational
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
