Thingiverse
Hard knob for height adjustment circular saw FESTOOL TS 55 EBQ
by alsen
14
Downloads
9
Likes
0
Makes
This is a reinforced knob to the nut (M6x10x30) used to adjust the height of the circular saw of my friend Davide P. whom I thank for the photos provided.
The greater resistance is obtained by printing the inner part along the horizontal plane of the 3d printer with a very high filling percentage (50-60%) and the outer part in vertical with a lower filling percentage of 20-25%.
This allows to obtain a good compromise between robustness, size and use of the mareriale.
The M6x10x30 nut i
The greater resistance is obtained by printing the inner part along the horizontal plane of the 3d printer with a very high filling percentage (50-60%) and the outer part in vertical with a lower filling percentage of 20-25%.
This allows to obtain a good compromise between robustness, size and use of the mareriale.
The M6x10x30 nut i
Sign in to leave a comment
Sign in