Thingiverse
Tevo Tarantula i3, Sides and Legs for Acrylic Display Case
by Zimmant
36
Downloads
23
Likes
1
Makes
This is a side panel cover and legs for the Acrylic display on the Tevo Tarantula and other similar i3 Printers.
The long sides are split in two pieces as my Tevo was being rebuilt when I designed this.
So these were made on my Monoprice Mini Select.
They are designed to slip over the brass standoffs, and will use all factory hardware with the exception of : 2 M3x16 cap screws and 2 M3 nuts for the split long sides .
: 4 M3x20 cap screws washers and nuts for bolting
The long sides are split in two pieces as my Tevo was being rebuilt when I designed this.
So these were made on my Monoprice Mini Select.
They are designed to slip over the brass standoffs, and will use all factory hardware with the exception of : 2 M3x16 cap screws and 2 M3 nuts for the split long sides .
: 4 M3x20 cap screws washers and nuts for bolting
Sign in to leave a comment
Sign in