Fidget Hand Quintuple Spinner / Ball Bearing Holder

Here is a remix version of my quintuple M14 Hex Nuts spinner.

This one is holding 6 standards 608 skateboard ball bearings (Ø22mm), 1 in the middle and 5 on the outside.

Good inertia and around 1min of spinning (depend on your bearing).

This spinner is lighter than my M14 nuts spinner version but the gyroscopic effect is very nice !

Hole diameters is Ø22.1mm for good bearings mounting.

7mm wide for perfect balance after bearing assembly.

I printed it using Blue glow in dark ABS