Stargate Handle (used on my i3 enclosure)

Remixed wtgibson's Stargate w/symbols into a handle for my 3d printer enclosure.

It is 150mm wide w/ holes for M4 screws.

Cut his 1-sided Stargate in half, duplicated remaining half to make it 2-sided, and added holes for M4 screws (about 7mm deep).

I printed it with the gate standing up on the buildplate. This did print with supports but it looked as if they weren't required. I did see a quality drop on the overhang just a bit.

Added benefit after I installed it: the reflection from