Boosted Board V1 and V2 Holder

This is just a simple wall mounted wheel holder I made. I made a version for the V1 and V2 wheels. 75mm fits the V1 InHeat wheels and the 80mm fits the V2 Kegel wheels.

75mm - V1
80mm - V2

The designs should hold up fine with PLA and a decently high infill. They will take a lot of time though. Considering that there is no bevel or chamfer on the edges, it should print fine no matter what setting you are using on its side.

Just use any long enough screw to drill into whatever material