18mm model rocket

This is a model rocket I designed to launch with my friend. The rocket accepts an 18mm model rocket engine, but feel free to increase or decrease the diameter to fit your engine. If you do re-upload this please include me as the original designer. You will need a parachute, a way to hold the nose cone to the body (I used paracord), and a model rocket engine (I used a c6-5 engine). You will also need some type of wadding the protect the parachute from the hot gasses of the engine (you can use actual wadding or just use a paper towel or a tissue). Also, you should use a launchpad and you will need a launch controller to ignite the engine. Finally, you will need a paper clip to put through the hole in the side of the rocket to stop the engine from flying out the top of the rocket.

After printing the rocket, make a hole in the bottom of the nose cone just off-center. Put the paracord and parachute strings into the hole and secure them however you wish (I usually fill the hole with super