mod for printing of nylon filament using stock xyzprinting firmware no firmware mods neaded

xyzprinting filament temperature adjustment to print nylon filament with stock firmware

finally have this dialed in the included picture is a buckle i printed in nylon
http://www.thingiverse.com/thing:312961

use ABS cartridge setting

i have finally got a roll of gizmo dork nylon

i have added a 500 ohm resistor parallel to the 500 ohm pot to make the range of the 500 ohm pot to 250 ohms giving a more accurate adjustments
actually the resistor i used is 560 ohms my resistor pack goe