Thingiverse
Inside filament holder for Flashforge Creator pro 2016
by Connelly46
93
Downloads
53
Likes
0
Makes
Inside Filament holder for Flashforge Creator Pro 2016.
Flashforge Dreamer lock a Like solution for my FCP 2016
Projects because I was tired of constantly rummage in the back of my 3D printer.
Simple easy system that you print in a few hours and 30 minutes to install.
Use double-sided tape to secure the holder in the bottom of the printer, so they are not slipping around and ruin your printer.
Have been using 6 mm air hose up to extruders, and 4 pieces of 2.5 mm steel pin. about 100
Flashforge Dreamer lock a Like solution for my FCP 2016
Projects because I was tired of constantly rummage in the back of my 3D printer.
Simple easy system that you print in a few hours and 30 minutes to install.
Use double-sided tape to secure the holder in the bottom of the printer, so they are not slipping around and ruin your printer.
Have been using 6 mm air hose up to extruders, and 4 pieces of 2.5 mm steel pin. about 100
Sign in to leave a comment
Sign in