Thingiverse
18mm auto level sensor support for Anet A8 right side
by lukeskymuh
341
Downloads
156
Likes
8
Makes
A stiff and stable sensor supoort for the Aner A8 and a LJ18A3-8-Z/BX or any other 18mm diameter sensor.
It is located on the right side to enable better acess to the extruder and placed so that a colision with the heat bed cable is avoided. The disadvantage is that it is located further away from the sensor than those located at the fan.
For autolevel instructions see:
https://3dprint.wiki/reprap/anet/a8/improvement/autobedleveling
Extended fan duct:
http://www.thingiverse.com/thing
It is located on the right side to enable better acess to the extruder and placed so that a colision with the heat bed cable is avoided. The disadvantage is that it is located further away from the sensor than those located at the fan.
For autolevel instructions see:
https://3dprint.wiki/reprap/anet/a8/improvement/autobedleveling
Extended fan duct:
http://www.thingiverse.com/thing
Sign in to leave a comment
Sign in