Thingiverse
LED light for 3D printer
by 7eggert
9
Downloads
9
Likes
0
Makes
LED light for the heatbed
4 LED, mounted above the heatbed on my Prusa i3 A8 using existing screw holes.
Warning, the screws must be level with the surface, otherwise the extruder will be blocked. I shortened 2 30 mm screws to fit.
I'm using 2 white LED for each side with a 470 Ohm resistor (12 V). It's bright enough to not need additional light for casually looking at the print, but it can't - off cause - reach the area right below the print head.
The internal support wasn't easy to r
4 LED, mounted above the heatbed on my Prusa i3 A8 using existing screw holes.
Warning, the screws must be level with the surface, otherwise the extruder will be blocked. I shortened 2 30 mm screws to fit.
I'm using 2 white LED for each side with a 470 Ohm resistor (12 V). It's bright enough to not need additional light for casually looking at the print, but it can't - off cause - reach the area right below the print head.
The internal support wasn't easy to r
Sign in to leave a comment
Sign in