Thingiverse
E3d Servo auto level prusa i3 or hypercube
by jh1985
74
Downloads
59
Likes
2
Makes
VIDEO TUTORIAL I USED TO SET UP AUTO LEVEL
https://www.youtube.com/watch?v=awsI9bMndJA&t=15s
Update 12/5/16
fan duct rev 2: Fixed mounting ear. Removed front of duct so i can see my nozzle. The old version made hard to make sure my first layer was going down right. I added 2 nozzles to aim air at the front.
print with supports touching build plate for best results
12/2/16 Fan duct added- not perfect one mounting whole is off i just drilled one. ill fix it later this week. print in cura wit
https://www.youtube.com/watch?v=awsI9bMndJA&t=15s
Update 12/5/16
fan duct rev 2: Fixed mounting ear. Removed front of duct so i can see my nozzle. The old version made hard to make sure my first layer was going down right. I added 2 nozzles to aim air at the front.
print with supports touching build plate for best results
12/2/16 Fan duct added- not perfect one mounting whole is off i just drilled one. ill fix it later this week. print in cura wit
Sign in to leave a comment
Sign in