Telaio_1e26 Car model scale 1:26

This is my personal design of a RC car in 1:26 scale (approximately).

All things are designed and printed by me in solid translucent blue PLA on my Ultimaker. Only 0.5 module 49 tooth gear was printed in yellow PLA.

For the car electronics I used an Arduino Mini compatible board, a Pololu DRV8835 motor driver and a rf24 2Euros RC module. The steering is commanded with a Hitec HS-55 feather servo.
The controller is made with a PS2 dualshock controller, another Arduino (Nano) and another r