Thingiverse
E3D Dual Printing
by okrim
138
Downloads
91
Likes
0
Makes
not testet !!
New: V2
-Tube Inside Diameter now 2.2mm
- flat backside for better Printing
Print with 0,1mm from inside to outside
NEW: V3
- longer guided Filament on the Pushfits and at the Exit to E3D
- shorter "Mixingzone"
NEW V4:
- remove some Rounding for better printing
- now 45° Overhang
NEW V5
- "Flat-Version"
- after Printing abort the little Support with Tongs
(i´m don't using Simplify3D)
New: V2
-Tube Inside Diameter now 2.2mm
- flat backside for better Printing
Print with 0,1mm from inside to outside
NEW: V3
- longer guided Filament on the Pushfits and at the Exit to E3D
- shorter "Mixingzone"
NEW V4:
- remove some Rounding for better printing
- now 45° Overhang
NEW V5
- "Flat-Version"
- after Printing abort the little Support with Tongs
(i´m don't using Simplify3D)
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in