Handle and top cap for Silca track bicycle tire pump

**Update 24 Feb 2019:** I've switched over to Fusion 360 for my modeling, so have been going back through my earlier SketchUp designs and remodeling them. I've included the new design as well as the F3D original.

Broke the handle on my vintage Silca track pump, measured and determined the thread on the pump shaft is an M10x1.5, so figured I could make my own handle. Got a custom M10x1.5 nut from the Nut Job thing, imported it into SketchUp and ditched the outside parts and just used the threa