Thingiverse
E3d Cyclops/Chimera CTC Single Carriage mount
by memmop
22
Downloads
10
Likes
0
Makes
This is my first design using Freecad.
I needed something to mount an E3d Cyclops to my Single aluminium carriage.
It has 2 holes for 5mm LEDs with a gap for a 1k 1/4 resistor in between. The leads then are routed to a 2 pin power plug like found on the main board.
Added hot end fan mounts (Not printed yet)
The carriage is like this
https://www.aliexpress.com/item/MakerBot-Replicator-2-Aluminum-Carriage-Fargo-3D-Printing/32689189193.html?spm=2114.01010208.3.1.Vp4kB9&ws_ab_test=searchweb0
I needed something to mount an E3d Cyclops to my Single aluminium carriage.
It has 2 holes for 5mm LEDs with a gap for a 1k 1/4 resistor in between. The leads then are routed to a 2 pin power plug like found on the main board.
Added hot end fan mounts (Not printed yet)
The carriage is like this
https://www.aliexpress.com/item/MakerBot-Replicator-2-Aluminum-Carriage-Fargo-3D-Printing/32689189193.html?spm=2114.01010208.3.1.Vp4kB9&ws_ab_test=searchweb0
Sign in to leave a comment
Sign in