Tevo Black Widow control box side mount

To finish this control box I needed:
2x 80mm fans
24x #6 x 1/2in Flat Phillips Wood screws
Zip ties (PSU is secured with a Zip tie to the base)
8x M4x10 + drop in nuts for AL extrusion (to mount the box to the printer)
one 3Pin IEC320 C14 Inlet with Fuse and Switch
a few smaller screws to mount the board, the display and the power plug

I had to pilot drill for every screw to avoid damaging the printed parts.

The knob for the smart controller will need some modification because it is