Thingiverse
"Power Pack" Enclosure for Adafruit PowerBoost
by Gunn
9
Downloads
4
Likes
0
Makes
A simple two part enclosure for the Adafruit PowerBoost 1000C and 4400mAh battery.
Enclosure has an opening for the optional switch on the PowerBoost, thus allowing the "Power Pack" to be turned on and off.
Small holes allow monitoring of the "Power Packs" condition via the on-board PowerBoost LED's.
Printing both pieces with the large flat side down.
Enclosure has an opening for the optional switch on the PowerBoost, thus allowing the "Power Pack" to be turned on and off.
Small holes allow monitoring of the "Power Packs" condition via the on-board PowerBoost LED's.
Printing both pieces with the large flat side down.
Sign in to leave a comment
Sign in