Thingiverse
Push Pin Magnet
by Karen5R
39
Downloads
26
Likes
0
Makes
This is a push pin designed to hold one of my favorite magnets. The pin is around 1/2" diameter at the bottom and 3/4" tall.
The magnet is a 1/8 by 3/8 cylinder magnet from magnet4less.com. The magnet is inserted into the hole in the bottom, and fits well enough not to need glue.
It prints well without support.
The magnet is a 1/8 by 3/8 cylinder magnet from magnet4less.com. The magnet is inserted into the hole in the bottom, and fits well enough not to need glue.
It prints well without support.
Sign in to leave a comment
Sign in