Thingiverse
Bullet Magnet
by Karen5R
27
Downloads
26
Likes
0
Makes
This is a bullet designed to hold one of my favorite magnets. The bullet is around 2/3" diameter and 2/3" tall.
The magnet is a 1/8 by 3/8 cylinder magnet from magnet4less.com. The magnet is inserted into the hole in the bottom, and fits well enough not to need glue.
It prints well without support.
Add a little gray paint for the lead and you've shot the fridge...oops...
The magnet is a 1/8 by 3/8 cylinder magnet from magnet4less.com. The magnet is inserted into the hole in the bottom, and fits well enough not to need glue.
It prints well without support.
Add a little gray paint for the lead and you've shot the fridge...oops...
Sign in to leave a comment
Sign in