Thingiverse
Peristaltic pump conversion for a 3d printer
by jimbit22
4
Downloads
3
Likes
0
Makes
This is a conversion i made to a commercial peristaltic pump to accept a stepper motor.
It was easier than editing the whole firmware in order to use it properly.
it can be seen working here:
https://www.youtube.com/watch?v=KB8H-T4nDkI
Its a simple geared system so there is alot of backlash but its not made for precision dispensing.
The secondary gear has space to press fit 625zz bearings. Modification on the body of the donor peristaltic pump is needed in order to fit the gears and d
It was easier than editing the whole firmware in order to use it properly.
it can be seen working here:
https://www.youtube.com/watch?v=KB8H-T4nDkI
Its a simple geared system so there is alot of backlash but its not made for precision dispensing.
The secondary gear has space to press fit 625zz bearings. Modification on the body of the donor peristaltic pump is needed in order to fit the gears and d
Sign in to leave a comment
Sign in