iMac 2.5" HD Holder

This thing was made with Tinkercad.

I've made this holder to fix a 2.5" hard drive invisible on the backside of my iMac.
You can print it without Brim and supports.
I've minimized all to kept the printing time low (ca. 30" on a Vertex 8400).
I used two 4-5 mm broad rings, cutted from a bicicle tire to fix the HD on the holder.
This clip is fitting so far on a 27" iMac (2009) and on a 21" Retina iMac with aluminium case.