Thingiverse
Low Profile Print cooling duct for E3D V6 authentic
by DRPrinting3D
99
Downloads
58
Likes
1
Makes
I needed a cooling duct that would fit my authentic E3D V6 which is installed in this orientation. This cooling duct blows the air mostly down, and a little out to cool the print, and not the hotend.
The hotend mount I used can be found here - http://www.thingiverse.com/thing:1570168
**UPDATE 1/24/17** - Made the holes in the bottom a little smaller to force air to go around the ring more, and >come out with more force at lower speeds.
The hotend mount I used can be found here - http://www.thingiverse.com/thing:1570168
**UPDATE 1/24/17** - Made the holes in the bottom a little smaller to force air to go around the ring more, and >come out with more force at lower speeds.
Sign in to leave a comment
Sign in