Slicer Discord
1997 Sojourner Mars Rover – Modello 3D stampabile da Thingiverse Thingiverse

1997 Sojourner Mars Rover

32 Download
26 Likes
0 Makes
Vai al Modello
#The First Rover on Mars!
This is a model of the Pathfinder Mission Sojourner rover. Way back in 1997, this little "micro rover" made the first drive on the red planet. Though it was intended to serve as an experiment to see if NASA's expensive r/c toys could function on Mars, Sojourner exceeded expectations and collected thousands of pictures and data during its 85-day operation. On September 27 of the same year, contact was lost with Pathfinder and Sojourner, bringing an end to the mission four months later. However, the last confirmed command sent to Sojourner was to continue driving around the lander, which it may still be doing to this day...
___
I built this model to go with the Perseverance Rover model I've printed previously. Therefore, the model seen in the thumbnail is printed at 117.5%. Print larger or smaller if you'd like, but be warned- getting the suspension out of the supports without breaking is tricky. And finally, the "pins" where the suspension attaches
Fonte
Thingiverse
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
PLA, ASA
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione