Thingiverse
19mm Power button
by snowth1ef
39
Downloads
45
Likes
0
Makes
***Needs to be scaled by 10 for some reason***
Not sure why, I did the measurements in mm in autodesk inventor, when importing the item into my slicer it has to be scaled up by 10, your results may vary.
19mm Power button for standard pc power switch, the switch i used came out of a silverstone case and measures 8x8mm.
Light shines through nice and bright.
Tolerances are a little tight, I filed my part a little bit, it may be helpful to print the socket 3-5% bigger.
Make sure to print the socket with the square hole down, otherwise there is quite a bridge.
Infill shouldn't matter, but I would recommend using the same or smaller layer height, as it may affect the thin layer the light shines through.
Not sure why, I did the measurements in mm in autodesk inventor, when importing the item into my slicer it has to be scaled up by 10, your results may vary.
19mm Power button for standard pc power switch, the switch i used came out of a silverstone case and measures 8x8mm.
Light shines through nice and bright.
Tolerances are a little tight, I filed my part a little bit, it may be helpful to print the socket 3-5% bigger.
Make sure to print the socket with the square hole down, otherwise there is quite a bridge.
Infill shouldn't matter, but I would recommend using the same or smaller layer height, as it may affect the thin layer the light shines through.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
