Thingiverse
1S XT30 holder Eachine Trashcan / Mobula7
door iFrostizz
2
Downloads
3
Likes
0
Makes
Hey!
Here is a fresh .STL file that could be very useful if you did the "XT-30" Upgrade on your tiny brushless whoop !
One part will hold the XT-30 and the other one will hold the two lipos so you can run it 2S.
You should print it in TPU with 100% infill
The XT-30 hold is a little tight, you can use a very thin screwdriver to put it inside and it'll never move in flight.
Here is a fresh .STL file that could be very useful if you did the "XT-30" Upgrade on your tiny brushless whoop !
One part will hold the XT-30 and the other one will hold the two lipos so you can run it 2S.
You should print it in TPU with 100% infill
The XT-30 hold is a little tight, you can use a very thin screwdriver to put it inside and it'll never move in flight.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
