Thingiverse
1U Rack Ceiling Bracket
von NoobyNoobNoob
7
Downloads
3
Likes
0
Makes
Needed to get my Ubiquiti out of the way in my cupboard, this should work with all 1u racks
No supports needed to print.
FYI some dude on Reddit advised that the brackets may dry out and be brittle you should print with PETG / I do not have the experience to advise one way or the other, but I would rather say than not.
I have printed in PLA - but will probably replace when I get some PETG. Will report back as time goes on
Source
https://www.reddit.com/r/Ubiquiti/comments/11oprtk/u1_ceilingmount_to_get_it_out_to_way_link_in/jbtxzuy/
No supports needed to print.
FYI some dude on Reddit advised that the brackets may dry out and be brittle you should print with PETG / I do not have the experience to advise one way or the other, but I would rather say than not.
I have printed in PLA - but will probably replace when I get some PETG. Will report back as time goes on
Source
https://www.reddit.com/r/Ubiquiti/comments/11oprtk/u1_ceilingmount_to_get_it_out_to_way_link_in/jbtxzuy/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
