Thingiverse
2 1/4 ventilation pipe splitter
par EB7571
23
Téléchargements
17
Likes
0
Makes
I designed this so that the ventilation pipes for a ShopBot Desktop could fit over the end pieces but they are standard 2.25in pipes (inner diameter). There are 3 parts to print;
1.) Y splitter: the main part (print one per set)
2.)Y adapter: the smaller tube which is used to create a channel to fit the stopper into (must print one each of the 3 openings). The tabs on the end are used for lining up the pieces, I'd recommend superglue.
3.) Y closer: the flat piece that closes off each pipe after the other two parts have been connected (print 3 for each opening).
Since this is an important piece I wouldn't recommend anything less than 50% infill, 75% in good and 100% is best case scenario. Supports 100% needed for every print, no acceptations. As well I always add the SolidWorks file if possible, I have had trouble opening these from thingaverse but I believe it's only because I have an only version.
In order to fit the print onto my Makerbot Replicator + I had
1.) Y splitter: the main part (print one per set)
2.)Y adapter: the smaller tube which is used to create a channel to fit the stopper into (must print one each of the 3 openings). The tabs on the end are used for lining up the pieces, I'd recommend superglue.
3.) Y closer: the flat piece that closes off each pipe after the other two parts have been connected (print 3 for each opening).
Since this is an important piece I wouldn't recommend anything less than 50% infill, 75% in good and 100% is best case scenario. Supports 100% needed for every print, no acceptations. As well I always add the SolidWorks file if possible, I have had trouble opening these from thingaverse but I believe it's only because I have an only version.
In order to fit the print onto my Makerbot Replicator + I had
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !