MakerWorld
Electronics
Vai al Modello
2"5 HDD enclosure
26
Download
4
Likes
17
Makes
Hi! I made this rugged case to protect a 2.5" HDD. It's a two-part case, the top and the bottom. To close it, I recommend using M3 screws by 10mm. If you have a HDD that's a bit thin, like an SSD, you can use other screws on the side to hold it in place even better! There you go, I hope it works for you.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
