Thingiverse
2 channel non usb eletronic relay case
door Mago3d
21
Downloads
10
Likes
0
Makes
Found this neat case for a double relay, just my relay was not an USB one, but one that would be controlled via the raspberry PI GPIO connectors using Dupont cables.
My remix consisted in:
1-Close the opening for the USB connector
2-Open a slot for the Dupont wires to come in and connect to the relay
3-Bring the holes where to screw the relay board closer together.
12/17/2018
-Added another lower case for a different model of relay switch.
-Renamed the lower case file names to now include the distance (in mm) between the screw holes on the relay switch board.
Printed with:
0.1 mm layer
50% infill
no support
5 lines brim
My remix consisted in:
1-Close the opening for the USB connector
2-Open a slot for the Dupont wires to come in and connect to the relay
3-Bring the holes where to screw the relay board closer together.
12/17/2018
-Added another lower case for a different model of relay switch.
-Renamed the lower case file names to now include the distance (in mm) between the screw holes on the relay switch board.
Printed with:
0.1 mm layer
50% infill
no support
5 lines brim
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!